Search BackCountrySignal

    Open full search pageSearches run in your browser. Nothing you type is sent anywhere.

    Hardware · Source briefing

    An open-source Meshtastic collar tracker for pets

    Published · Source checked

    The story

    Hackaday covers LIA, a collar tracker built on a custom board with an ESP32-S3, a LoRa radio and GPS, in a 3D-printed case. It charges through a magnetic pogo connector for weather resistance and has a high-power mode with a fix about every 30 seconds plus two bright LEDs, a low-power mode with a fix about once a minute, and a full off switch. The article and its comments raise unanswered questions about US FCC compliance. This is a project-reported design, not tested hardware.

    What it means for your next build

    A tracker only helps where your mesh reaches. Before trusting one for a dog in the woods, walk the area with a test node and confirm positions arrive from the hollows and creek bottoms, not just the ridgelines.

    Check coverage

    This is BackCountrySignal's own short briefing. Read the original source for its complete details. Firmware and app announcements do not establish tested Graham County Mesh compatibility.